12 V One-Hand Recip Saw Sleeve with Blade Sheath - Backstage cart lip (one piece, strongest)
======================================================================

What it holds: Nose-down cone sleeve for a 12 V one-hand reciprocating saw (e.g. M12 Hackzall size) with a CP stem pack. The blade sits in a closed sheath.

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - H_RF_saw_sleeve_lip.stl  (supports: no (unless your slicer warns))

HOW IT MOUNTS
  BACKSTAGE CART LIP (ONE PIECE, STRONGEST)
    The cart-lip slot is printed into the holder, so it is one piece and as strong as it gets.
    Hold it tilted, hook the slot over the upright lip on the edge of a Magliner / Backstage-style cart
    shelf, and rock it down until it sits flat against the side.

    Notes for this holder: One piece with the Magliner/cart lip block (strongest). The sleeve sits 7.5 mm closer to the cart and 8 mm higher than on the DOCK adapter; back plate bears on the cart side. Optional M5 heat-set insert + M5 thumbscrew clamps the lip. Prints upright like the DOCK version; turn on support ON THE BUILD PLATE ONLY: it only lands under the lip block's inner flange (the rest needs none). ~251 g.

HOW IT WORKS
  The saw goes in nose first. The bore is a cone (64 mm at the top, 42 at the bottom), so any nose from 42 to 62 mm seats itself, with no measuring. Below it, the blade drops into a closed sheath (20 x 46 mm inside, 115 long, with a drain), so blades up to 6 in never ride exposed on the cart.
  Two flex bump bands stop rattle. A front window shows the tool.
  Pack size: use it with CP 2.0-3.0 Ah stem packs. With an XC 4 Ah pack the saw is about 1.5-1.6 kg, over the 1.5 kg rating of a single DOCK tongue.
  Note: it is 244 mm tall and hangs 210 mm below the deck, so check the shelf below.
  Mounting (DOCK system): the back carries one DOCK tongue. Drop it into DOCK carrier adapters (Magliner / Backstage lip, ToughBuilt bar, round or square tube, T-slot; all in the DOCK system listing) and it clicks in. To take it off, push the release pad with your thumb and lift. Fit the adapter's M5 lock thumbscrew: this holds a heavy tool well out from the cart.

OTHER MOUNTS
  The same holder also comes ToughBuilt bar (one piece), Dock (swap between mounts), Mountless (desk, shelf, case or screw to a panel). Pick the mount on the site: https://cart-tools.sdos-placeholder.workers.dev/#rf-saw-sleeve

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
