Meter Holster Fit Coupon (Sekonic L-858D / C-800 cradle rings)
==============================================================

What it holds: Two 15 mm rings of the holster cavities: check the fit on your meter before the full print (~9 g).

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - PZ_fit_coupon.stl  (supports: no)

HOW IT MOUNTS
  Test piece: lies flat on the bench, used to check fit before printing the real parts.

HOW IT WORKS
  Two 15 mm tall rings, the exact cross-section of each holster: corner rails, side relief channels and front relief, labelled 858 and C800. Slide a ring down over the meter from the bottom. It should have 0.5-1 mm of side play and the corners must not bind. Push the meter onto the front rails: they must sit on the rounded body corners and not on the screen glass. The back gap should then be 1.2-2 mm (the flex fingers take this up). About 9 g, flat, no supports.
  Fits the Sekonic L-858D and C-800 (sizes from the Sekonic manuals). Not affiliated with Sekonic, Backstage Equipment, Magliner or ToughBuilt.

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

More holders and the latest versions: https://cart-tools.sdos-placeholder.workers.dev/#pz-fit-coupon

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
