One-Wrap Roll Holder - Backstage cart lip (one piece, strongest)
================================================================

What it holds: One roll of One-Wrap strap, 1/2-1 in, 3 in core, up to 200 mm across

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - clip_KA_wrap_roll.stl  (supports: no)
  - clip_KC_lock_cap_3in.stl  (supports: no)

HOW IT MOUNTS
  BACKSTAGE CART LIP (ONE PIECE, STRONGEST)
    The cart-lip slot is printed into the holder, so it is one piece and as strong as it gets.
    Hold it tilted, hook the slot over the upright lip on the edge of a Magliner / Backstage-style cart
    shelf, and rock it down until it sits flat against the side.

    Notes for this holder: One piece with the native Magliner / Backstage cart-lip mount (the shipped part). Prints on its end (y0 face), no supports. Cap prints flat. Includes the quarter-turn lock cap.

HOW IT WORKS
  For crews who cut their own wraps to length from a roll. The roll stands on edge against the cart side, so it sticks out only as far as its width, not its diameter.
  What fits

  - One roll of One-Wrap style back-to-back hook-and-loop strap, 1/2 to 1 in wide, on a 3 in (76 mm) core
  - Up to 200 mm across (a full 25 yd roll; the roll's outside size varies by maker and thickness, so measure yours)
  - Will not fit: small retail rolls on cores smaller than 3 in
  Locked on
  The 74 mm spindle ends in a T-head. Slide the roll on, push the cap (KC_lock_cap_3in, included in this collection) over the T-head and turn it 90 deg until it clicks (a 1.5 mm relief ring under the cap lets its tongues flex). The roll cannot come off over bumps. The cap is the same as our gaff and tape holders' cap, so any of them fits. Hook-and-loop strap grips itself, so the roll does not unwind on its own and needs no brake.
  Exit lip
  A smooth bar under the roll with a 6 mm round on its outer edge and no teeth. Pull the tail down over it and cut with scissors against its straight edge. The cut end rests on the lip, ready for the next pull.
  Numbers

  - Sticks out 58 mm from the cart side with the cap on
  - Hangs 148 mm below the deck
  - Needs 80 mm of flat cart side below the lip for the back plate. Below that, the part stands 4 mm off the cart
  - Overall 76 x 70 x 190 mm (out x along the cart x tall)
  - A full 200 mm roll reaches 70 mm above the deck, outside the cart

OTHER MOUNTS
  The same holder also comes ToughBuilt bar (one piece), Dock (swap between mounts), Mountless (desk, shelf, case or screw to a panel). Pick the mount on the site: https://cart-tools.sdos-placeholder.workers.dev/#ka-wrap-roll

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
