One-Wrap Cable Wrap Station - Backstage cart lip (one piece, strongest)
======================================================================

What it holds: Pre-cut hook-and-loop wraps: bulk on a closed bar, 1/2, 3/4, 1 in sorted on the keeper strip

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - clip_KA_wrap_bar.stl  (supports: no)

HOW IT MOUNTS
  BACKSTAGE CART LIP (ONE PIECE, STRONGEST)
    The cart-lip slot is printed into the holder, so it is one piece and as strong as it gets.
    Hold it tilted, hook the slot over the upright lip on the edge of a Magliner / Backstage-style cart
    shelf, and rock it down until it sits flat against the side.

    Notes for this holder: One piece with the native Magliner / Backstage cart-lip mount (the shipped part). Prints on its end (y0 face), no supports.

HOW IT WORKS
  Everyone on set wraps cable all day, and the wraps live on belt loops or get lost in the drawer. This station keeps the cart's own supply on the side of the cart.
  The wrap bar
  A 16 mm round bar, 110 mm long, closed at both ends by arms back to the plate. Wind pre-cut wraps round it (Velcro One-Wrap, Rip-Tie and similar), and keep winding new ones on top: hook-and-loop wraps grip the loop back of the wrap underneath, so the bundle builds up like a roll. There is 22 mm of clear space between the bar and the plate (18 mm lower down), so a fat bundle still fits. Because the bar is closed at both ends, a wrap can never slide off it, even on a lift-gate drop. To take one, pinch the outer tail and rip.
  The keeper strip
  Under the bar, three slots 14, 20 and 30 mm wide, engraved 1/2, 3/4 and 1, each with its own 12 x 8 mm rounded bridge and 12 mm of clear space behind it. Wrap that size of strap round its own bridge, so the stingers' 3/4 in wraps stay apart from the 1/2 in SDI wraps and the 1 in feeder wraps. The tails hang down where you can see and grab them.
  Everything a wrap touches is rounded, so the hook side does not snag on sharp corners.
  Numbers

  - Sticks out 46 mm from the cart side (the bar's front face; a full wrap bundle on it adds about 15 mm)
  - Hangs 104 mm below the deck
  - Needs 45 mm of flat cart side below the lip for the back plate. Below that, the part stands 4 mm off the cart
  - Overall 64 x 130 x 146 mm (out x along the cart x tall)

OTHER MOUNTS
  The same holder also comes ToughBuilt bar (one piece), Dock (swap between mounts), Mountless (desk, shelf, case or screw to a panel). Pick the mount on the site: https://cart-tools.sdos-placeholder.workers.dev/#ka-wrap-bar

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
