Label test
==========

What it holds: 20 mm crush-rib test slice for labels; print first

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - clip_HZ_label_fit_test.stl  (supports: no)

HOW IT MOUNTS
  Backstage cart lip: the slot is built in. Hold it tilted, hook the slot over the upright lip on the edge of a Magliner / Backstage-style cart shelf, and rock it down until it sits flat against the side.

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

More holders and the latest versions: https://cart-tools.sdos-placeholder.workers.dev/#hz-label-fit-test

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
