4x5.65 Filter Pocket - Backstage cart lip (one piece, strongest)
================================================================

What it holds: Filter pouches up to 180 x 15 mm

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - clip_DC_filter_pocket.stl  (supports: no)

HOW IT MOUNTS
  BACKSTAGE CART LIP (ONE PIECE, STRONGEST)
    The cart-lip slot is printed into the holder, so it is one piece and as strong as it gets.
    Hold it tilted, hook the slot over the upright lip on the edge of a Magliner / Backstage-style cart
    shelf, and rock it down until it sits flat against the side.

    Notes for this holder: One piece with the Magliner/cart lip block (the shipped part). Optional M5 heat-set insert + M5 thumbscrew lip clamp. Prints upside down (rims + block top on the bed), no supports.

HOW IT WORKS
  A two-slot pocket for the working filters of the day, 4x5.65 in their pouches only (never bare glass), standing on edge along the cart. Use it on the cart end.
  Fits: Backstage Equipment and Magliner-style carts with a 3.4 mm upright shelf lip at least 16 mm tall. The part drops onto the lip through a 3.7 mm slot (0.3 mm clearance), 26.6 mm deep with a round end, with 0.5 mm chamfers at both slot ends.
  2 slots, each 16 mm wide, 184 mm long inside and 110 mm deep: pouches up to 180 x 15 mm fit (bare filter 143.5 mm; padded single pouches run about 160-180 mm). Measure your pouches. A V finger notch runs through the front wall and the divider so you can pinch either pouch out. One 5 mm drain per slot, and a small notch across each rim end over each slot for a ranger band or hair tie to hold the pouches in on a rough push. Size 65 x 192 x 115 mm.
  On the cart: sticks out 47 mm from the cart side, hangs 73 mm below the deck, and needs a flat cart side 65 mm deep below the lip for the back plate to bear on.
  Retention: held by gravity unless you fit the M5 thumbscrew. Press an M5 short heat-set insert into the two holes on the shelf-side face (6.4 mm x 9 mm deep) and use a nylon-tipped M5 thumbscrew: it clamps the lip against the outer wall, so the part cannot lift off on a bump, slide along the lip or rattle.

OTHER MOUNTS
  The same holder also comes ToughBuilt bar (one piece), Dock (swap between mounts), Mountless (desk, shelf, case or screw to a panel). Pick the mount on the site: https://cart-tools.sdos-placeholder.workers.dev/#dc-filter-pocket

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
