Flashlight Holster - Backstage cart lip (one piece, strongest)
==============================================================

What it holds: 1 in body flashlight, tail cap up to ~28 mm

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - clip_CC_flashlight_holster.stl  (supports: no)

HOW IT MOUNTS
  BACKSTAGE CART LIP (ONE PIECE, STRONGEST)
    The cart-lip slot is printed into the holder, so it is one piece and as strong as it gets.
    Hold it tilted, hook the slot over the upright lip on the edge of a Magliner / Backstage-style cart
    shelf, and rock it down until it sits flat against the side.

    Notes for this holder: One piece with the Magliner/cart lip block (shipped part, strongest). Hangs by gravity; optional M5 heat-set insert + thumbscrew clamps the lip. Prints upside down (rims on the bed), no supports. ~87 g.

HOW IT WORKS
  A tail-down holster for a small pro flashlight: Fenix PD-class, head up to 36 mm, 1 in (25.4 mm) body (Streamlight ProTac, Olight Warrior, SureFire class). Grab it blind in the dark with one straight pull.
  Fits: Backstage Equipment and Magliner-style carts with a 3.4 mm upright shelf lip at least 16 mm tall. The part drops onto the lip through a 3.7 mm slot (0.3 mm clearance), 26.6 mm deep with a round end, with 0.5 mm chamfers at both slot ends.
  The pocket tapers from 37 mm at the rim to 28.5 mm at 65 mm deep, where the tail rests on a 45 degree funnel floor, so a short light stays within reach. A tail cap or lanyard ring up to 28 mm sits on the floor; anything larger rides higher. An 11 mm front slot lets the pocket clip ride outside; over its lower 40 mm it widens to 18 mm as a push-out window, so you can push a short light up with a finger. 10 mm drain in the floor. Needs about 60 mm of clear cart side; not for the bottom shelf. Size 67 x 50 x 78 mm.
  On the cart: sticks out 49 mm from the cart side, hangs 36 mm below the deck, and needs a flat cart side 23 mm deep below the lip for the back plate to bear on.
  Retention: held by gravity unless you fit the M5 thumbscrew. Press an M5 short heat-set insert into the one hole on the shelf-side face (6.4 mm x 9 mm deep) and use a nylon-tipped M5 thumbscrew: it clamps the lip against the outer wall, so the part cannot lift off on a bump, slide along the lip or rattle.

OTHER MOUNTS
  The same holder also comes ToughBuilt bar (one piece), Dock (swap between mounts), Mountless (desk, shelf, case or screw to a panel). Pick the mount on the site: https://cart-tools.sdos-placeholder.workers.dev/#cc-flashlight-holster

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
