Tilt-Out Drawer 2x1 (Gridfinity floor, clear roof) - Backstage cart lip (one piece, strongest)
======================================================================

What it holds: A drawer that tips forward 40 deg when you pull its lip, then clicks shut. Gridfinity floor, clear roof, one DOCK tongue.

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - case_CH_tilt_housing_2x1_lip.stl  (supports: no (unless your slicer warns))
  - case_CH_tilt_bin_2x1.stl  (supports: no (unless your slicer warns))
  - case_CH_tilt_roof_clear.stl  (supports: no (unless your slicer warns))

HOW IT MOUNTS
  BACKSTAGE CART LIP (ONE PIECE, STRONGEST)
    The cart-lip slot is printed into the holder, so it is one piece and as strong as it gets.
    Hold it tilted, hook the slot over the upright lip on the edge of a Magliner / Backstage-style cart
    shelf, and rock it down until it sits flat against the side.

    Notes for this holder: One piece with the Magliner/cart lip mount, strongest. Prints upright on one flat face (housing floor + mount bottom), no supports. Optional: M5 heat-set insert(s) from the deck side + M5 x 20 nylon-tip thumbscrew stop lift-off.

HOW IT WORKS
  Pull the lip and the bin tips toward you to a hard stop at 40 deg, so you can see in and reach in. Push it back and it clicks shut. Gravity holds it shut (its weight sits behind the front pivot), and two side detents click it home so it stays put on a moving cart.
  Numbers

  - Outside: 52.7 deep x 94.7 wide x 54 tall
  - Tilt bin floor: 2x1 Gridfinity, 22 mm above the grid at the back wall (fits 3u bins with a stacking lip)
  - Pivot: two 6 mm printed pegs that click down cheek channels into their holes. No hardware.
  - Clear roof slides in from the front and clicks past two small bumps
  - The tall drawer front is the label (SMALLS, raised 0.6 mm)
  - Filament (estimated): housing 34 g, bin 18 g, clear roof 10 g
  DOCK tongue on the back: it clicks into any DOCK carrier adapter (Magliner/Backstage lip, ToughBuilt bar, round tube, T-slot). Drop-in floor compatible with Gridfinity (Gridfinity by Zack Freedman, MIT licence): standard bins, our insert set and community bins all drop into the slots.

OTHER MOUNTS
  The same holder also comes ToughBuilt bar (one piece), Dock (swap between mounts), Mountless (desk, shelf, case or screw to a panel). Pick the mount on the site: https://cart-tools.sdos-placeholder.workers.dev/#case-ch-tilt-housing-2x1

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
