T-Slot Rail Adapter
===================

Aluminium T-slot extrusion. 20: 6 mm slot (20 series). 40: 8 mm slot (30/40 series). _h for a horizontal rail, _v for an upright. Two drop-in T-nuts hold it.

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load.

WHAT IT IS
  A dock adapter. It holds the receiver that any swappable holder on the site clicks into: print the
  holder's Dock (swap between mounts) version, fix this adapter to your carrier, and drop the holder in
  from above until it clicks. Press the release pad and lift to take it off.
  Lock screw (every adapter): 1 x M5 short heat-set insert + 1 x M5 x 25 knurled thumbscrew (DIN 464) in the 45-degree lock boss. Optional on a bench, use it on moving carts and lift gates.

FILES
  - A_TSLOT_20_h.stl
      fits: aluminium T-slot, 6 mm slot (20 series), horizontal rail
      hardware: 2 x M5 drop-in T-nut (6 mm slot) + 2 x M5 x 10 socket cap screw (4 mm hex key, fitting only)
      rating: 1.5 kg with the lock screw (screwed into the frame) once it passes the bench drop test
      on the plate: on its -y cheek (latch arm and tab flat on the bed), no supports
  - A_TSLOT_20_v.stl
      fits: aluminium T-slot, 6 mm slot (20 series), vertical upright
      hardware: 2 x M5 drop-in T-nut (6 mm slot) + 2 x M5 x 10 socket cap screw (4 mm hex key, fitting only)
      rating: 1.5 kg with the lock screw (screwed into the frame) once it passes the bench drop test
      on the plate: on its -y cheek (latch arm and tab flat on the bed), no supports
  - A_TSLOT_40_h.stl
      fits: aluminium T-slot, 8 mm slot (30/40 series, 8 mm slot), horizontal rail
      hardware: 2 x M5 drop-in T-nut (8 mm slot) + 2 x M5 x 12 socket cap screw (4 mm hex key, fitting only)
      rating: 1.5 kg with the lock screw (screwed into the frame) once it passes the bench drop test
      on the plate: on its -y cheek (latch arm and tab flat on the bed), no supports
  - A_TSLOT_40_v.stl
      fits: aluminium T-slot, 8 mm slot (30/40 series, 8 mm slot), vertical upright
      hardware: 2 x M5 drop-in T-nut (8 mm slot) + 2 x M5 x 12 socket cap screw (4 mm hex key, fitting only)
      rating: 1.5 kg with the lock screw (screwed into the frame) once it passes the bench drop test
      on the plate: on its -y cheek (latch arm and tab flat on the bed), no supports

TEST THE FIT FIRST
  Print the fit coupons from the Test pieces section and check them on your own gear before a long print.

Holders that click into it: https://cart-tools.sdos-placeholder.workers.dev/

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
