ToughBuilt Bar Adapter
======================

Hooks the top edge of the steel bar on ToughBuilt StackTech / ClipTech. Print ONE: T2p5 for a thin (about 2 mm) steel edge, T7p65 for a 7.3 mm edge. Check with the ToughBuilt fit coupon first.

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load.

WHAT IT IS
  A dock adapter. It holds the receiver that any swappable holder on the site clicks into: print the
  holder's Dock (swap between mounts) version, fix this adapter to your carrier, and drop the holder in
  from above until it clicks. Press the release pad and lift to take it off.
  Lock screw (every adapter): 1 x M5 short heat-set insert + 1 x M5 x 25 knurled thumbscrew (DIN 464) in the 45-degree lock boss. Optional on a bench, use it on moving carts and lift gates.

FILES
  - A_TBB_bar_T2p5.stl
      fits: ToughBuilt StackTech/ClipTech steel bar, top edge (throat from TB_fit_coupon)
      hardware: 1 x M5 short heat-set insert + 1 x M5 x 12 knurled thumbscrew (bar clamp, turned by hand)
      status: HOLD - do not print until the owner measures lift room above the bar and the box face below it
      on the plate: on its -y cheek (latch arm and tab flat on the bed), no supports
  - A_TBB_bar_T7p65.stl
      fits: ToughBuilt StackTech/ClipTech steel bar, top edge (throat from TB_fit_coupon)
      hardware: 1 x M5 short heat-set insert + 1 x M5 x 12 knurled thumbscrew (bar clamp, turned by hand)
      status: HOLD - do not print until the owner measures lift room above the bar and the box face below it
      on the plate: on its -y cheek (latch arm and tab flat on the bed), no supports

TEST THE FIT FIRST
  Print the fit coupons from the Test pieces section and check them on your own gear before a long print.

Holders that click into it: https://cart-tools.sdos-placeholder.workers.dev/

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
